TECHNICAL DATA. KN/A. EPITAXIAL PLANAR NPN TRANSISTOR. Revision No: 0. GENERAL PURPOSE APPLICATION. SWITCHING APPLICATION. KNA Description = General Purpose Transistor ;; Package = TO Part Category: Transistors Manufacturer: KEC Corporation Description: Small Signal Bipolar Transistor, A I(C), 40V V(BR)CEO, 1-Element, NPN, Silicon, TO -.
|Published (Last):||1 May 2005|
|PDF File Size:||4.31 Mb|
|ePub File Size:||4.55 Mb|
|Price:||Free* [*Free Regsitration Required]|
Discussion in ‘ The Projects Forum ‘ started by terrikApr 5, Problem with transistor and a motor Reply to Thread.
KN2222A Datasheet PDF
Traansistor 5, 1. Feb 23, 3 0. To control the servo I build a H bridge circuit that is working fine. My problem is related with my inability to fully saturate the power transistor i recycled from the old board, it’s a NPN transistor 2SC My first hypothesis is that the arduino doesn’t provide enouth current to saturate the power transistor.
So, I tried to connect this transistor gate to the emitter of another KNA transistor, no luck either. The motor uses 0. I have little electronics background so maybe I’m missing something obvious. The circuit below is the last attempt to make this work with the two transistors.
Thank you in advance. Apr 5, 2. Apr 16, 3, 1, The first thing I notice about the 2SC is its pinout: I suppose that you have made certain of your wiring? Apr 5, 3. Thanks for the replay. Yes, I certainly did check many times. Apr 5, 4. Feb 12, Shouldn’t there be a resistor between the arduino pin and the transistor base? Seems like it should work fine with a single transistor.
I was just speculating the base current might be pulling down your voltage source you could measure the base voltage to check for that. Apr 5, 5.
KNA (KEC) – General Purpose Transistor, Package = TO | eet
Dec 29, 1, I simulated your motor circuit and and looks like it should work. I dont have 2sc transistlr I used 2sc which is about half the spec of your transistor. I suspect that your KNA is bad or low gain. You can try with any general purpose transistor like 2N or BC Dont forget to put a diode across the motor to protect your 2sc Apr 6, 6. Hi I tried what you said and it worked.
Problem with transistor and a motor | All About Circuits
But, before that I bought some TIP darlington in a local store to replace the C, and it worked perfectly. And then the C kn2222a working also fine. Maybe my cheap multimeter was messing around, maybe the USB wasn’t giving the 0. Connecting the gate at 12V immediately runs the motor, so transistor piout discarded. I checked so many times the wiring Maybe I just needed a morning out with the bike and your help. Anyway, now, connecting the 5V from the Arduino to the base directly just testing fully saturates the power transistor, but doing so shutdown the board in less than a second.
So, using the 30 ohms resistors, patricktoday suggested, works like charm. I’m going to put 8 diodes around the two H bridges thanks for the head up.
Also, I saw somewhere a cap in parallel with the diode, is that a good idea? Thank you for all the replies. Switching a 12vdc in2222a with a transistor Posted by Rich2 in forum: Newbie with a 2N transistor problem Posted by neville s in forum: You May Also Like: Find out in this Teardown Tuesday!
Digital Tattoos Bend The Limits Digital tattoos are an interesting implementation of an new category transstor “flexible electronics.
Create a no-fly zone! Your name or email address: Do you already have an account?
No, create an account now. Yes, my password is: Quote of the day.